If the paper is normal, can be a hardware failure possibility. Turn off the machine, is initialized, the sensor calibration. Sensor type has no right to choose, please confirm whether you label paper is spacing, black label, or continuous paper, and then select the corresponding sensor.Ĭheck the pressure of any printer to print. Real size of the label paper is not properly set in the software, please make sure the software set in the high label width and spacing and whether you actually use the same size. Machine does not have right to paper, please do hold the pause button on the way of test paper. TSC barcode printers ERR light has been on a red light, may be the following reasons: ( TSC barcode printers in the printing effect and speed are doing well, but there are still a customer because of ignoring the certain steps that there was a problem printing, most problems can be avoided.įor users to use on the situation when TSC barcode printers, small make up to the cause of the problem of the situation as follows, hope the broad masses of users can be ruled out for the corresponding fault, little detours! Users when using the TSC barcode printers for red light, small make up to this situation the cause of the problem to sort out the following Summary of TSC barcode printers in both the print effect and speed are doing well, but there are still a customer because of ignoring the certain steps that there was a problem printing, most problems can be avoided.
0 Comments
Leave a Reply. |